In a message dated 5/4/2001 2:07:54 PM Pacific Daylight Time,
LGMCAFEE@aol.com writes:
> I have some 6 inch aluminum rods that I am installing on a small block chev.
> My question is how much clearance should I have on the rod cap bolts as it
> swings past the block? I think I have read at least .100 does this sound
> right. Larry Mac
>
Larry,
I don't use aluminum rods, but the clearance you mentioned sounds fine
to me. I try for a minimum of about .060" on my Cunningham rods and cast-iron
block,,,,,,,,
Ardun Doug King
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
///
|