Hi Doug,
Its a 10,000 RPM two disk, with a Howe bearing and a CNC master cyl. The guy
at 10K said his fingers would work with that bearing. I haven't had the
thing together yet and was wondering about how much throw to allow for to
release the clutch after the free play is taken up?
Jim in Palmdale
i
----- Original Message -----
From: DOUG ODOM <popms@thegrid.net>
To: Jim Dincau <jdincau@qnet.com>
Cc: List Land Speed <land-speed@autox.team.net>
Sent: Sunday, November 05, 2000 7:25 AM
Subject: Re: Hydraulic throwout bearing
> Jim; We have run Tilton on race tracks for years with no problems. You
> have to set the free play correctly. Are you using a three disk clutch?
> You have to use the correct pressure plate fingers with the TO
> bearing. Doug Odom in big ditch
>
> Jim Dincau wrote:
>
> > Anybody out there running one of these?
> > How much pedal travel do you get?
> > I know it depends on cyl sizes and arm length but tell me what you run
and
> > I'll extrapolate.
> > Thanks.
> > Jim in Palmdale
|