| To: | Race Car <land-speed@autox.team.net> |
|---|---|
| Subject: | roll cage bracing |
| From: | Phillip Landry <saltracer@netscape.net> |
| Date: | 27 May 00 13:57:38 PDT |
Yea another roll cage question... On page 24 in figure 3&4 there are some gussets shown. Well the text says "gussets made from mild steel, .125"minimum thickness and four (4) inches per side..." OK where do you measure the 4 inches? Is the plate supposed to be 4 inches wide? We made some like that and they sure looked large. Phil and Gary ____________________________________________________________________ |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Hand Held Racers Density-Altitude Calculators, Keith Turk |
|---|---|
| Next by Date: | Contest very close, Jonathan Amo |
| Previous by Thread: | Hand Held Racers Density-Altitude Calculators, ARDUNDOUG |
| Next by Thread: | Re: roll cage bracing, Joe Timney |
| Indexes: | [Date] [Thread] [Top] [All Lists] |