Good morning all
Two days ago I installed a new washer on the large brass drain plug on the
67 BJ8 . Filled the transmission up . Looked at it in the morning and it had
drips on the bottom of the plug . So I used the correct tool and tried to
tighten it up . Then this morning looked again and there was those drips. When
I installed it the surface didnâ??t look gouged or anything. So whatâ??s the
fix to stop the drips ? Remove the big brass plug , get a new gasket for it ,
apply some kind of gasket sealer on the gasket, reinstall it and tighten as
needed? Maybe add two gaskets ?
Thanks as always, Don
Sent from my iPhone
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys
http://autox.team.net/archive/healeys
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|