healeys
[Top] [All Lists]

[Healeys] Trunk Lock Problem

Subject: [Healeys] Trunk Lock Problem
From: airtightproductions at icloud.com (Steven Kingsbury)
Date: Tue, 06 Feb 2018 21:09:27 +0000 (GMT)
Just went and remeasured from the inside edge of the metal covers of the bumper 
extensions.?
Left side:? ? ?15? 1/8 inch
Right side:? ?13 3/4 inch?
Off set:? ? ? ? ?1 3/8 inch to the right
?So now I'm really close to body #554
Steven?

On Feb 06, 2018, at 11:55 AM, Michael MacLean <rrengineer.mike at att.net> 
wrote:

Just measured mine. The body guy was very precise in his measurements before he 
welded it in place.? It measures 14 and 3/8ths inches on both sides. Crap.
Mike

Sent from Yahoo Mail on Android

On Mon, Feb 5, 2018 at 10:58 PM, WILLIAM B LAWRENCE
<ynotink at msn.com> wrote:
I think you are right.?My latch, by some miracle, works as it should.?



Measuring from the left bumper extension to the edge of the latch bracket gives 
15-1/4". Measuring from the right bumper extension to the edge of the latch 
bracket?gives 13-3/4". the latch bracket is 2-1/4" wide. Assuming that my car 
isn't too badly out of shape it looks as if the bracket is offset about 3/4" to 
the right. Maybe you can get your body man to correct it gratis since it's his 
mistake.



Good luck.



Bill Lawrence

BN1 #554

From: Healeys <healeys-bounces at autox.team.net> on behalf of Michael MacLean 
<rrengineer.mike at att.net>
Sent: Tuesday, February 6, 2018 5:33:40 AM
To: Healey List
Subject: [Healeys] Trunk Lock Problem
?
Can someone look at their 100 and give me some kind of measurement location for 
the angled bracket that is welded between the trunk floor and the support hoop 
for the rear shroud.? The trunk lid lock does not line up with the striker in 
the trunk, so I can not lock the trunk.? I suspect during the restoration when 
the new hoop and bracket were welded in, the body man simply welded the bracket 
in the center.? I suspect it should be off center to the right a bit looking 
from behind the car for proper alignment.? The trunk lock is a fixed location 
with no adjustment.? The striker does adjust left and right some, but not 
enough to line up correctly.? I am not looking forward to removing the bracket 
and re-welding it since it has been painted already.
Mike MacLean

Sent from Yahoo Mail on Android
_______________________________________________
Archive: http://www.team.net/archive

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys


-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20180206/651d083d/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>