| To: | Healey List <healeys@autox.team.net> |
|---|---|
| Subject: | [Healeys] speedo questions |
| From: | Bob Haskell <rchaskell@earthlink.net> |
| Date: | Sun, 4 Dec 2016 14:32:30 -0500 |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | healeys@autox.team.net |
| Domainkey-signature: | a=rsa-sha1; q=dns; c=nofws; s=dk20050327; d=earthlink.net; b=kd93crSJuCgB9/OGO7hTzgnKo4Tt0mGN7S9P84V/ZxjELIrOgDqUyjbIiqBy9S+j; h=Received:To:From:Subject:Message-ID:Date:User-Agent:MIME-Version:Content-Type:Content-Transfer-Encoding:X-ELNK-Trace:X-Originating-IP; |
| User-agent: | Mozilla/5.0 (X11; Linux x86_64; rv:38.0) Gecko/20100101 Thunderbird/38.8.0 |
Listers,
What's the thickness of the washer that is fitted between the gearbox
and the right angle drive (PN 3H550 or Moss PN 324-720)?
There are two MPH speedometers fitted to the 3000 MkI and MkII; one for
overdrive and one for non-overdrive cars. What's the speedometer
calibration (turns per mile) for each?
BMC P/N Smiths P/N TPM
non-OD BHA4124 SN6155/19 980???
OD BHA4126 SN6155/21 1080???
When fitting a 3.54:1 rear end to an overdrive equipped car, does the
non-OD speedometer have the correct calibration? I think that it would
if the gear ratios for the speedometer takeoffs on the extension housing
of the non-OD gearbox and on the overdrive were the same. If not, what
calibration (TPM) have folks used?
Cheers,
Bob Haskell
AHCA 3000 MkI registrar
http://www.ciahc.org/registry_3000mk1.php
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Healeys] rivets, healeymanjim |
|---|---|
| Next by Date: | Re: [Healeys] speedo questions, Bluehealey |
| Previous by Thread: | [Healeys] rivets, healeymanjim |
| Next by Thread: | Re: [Healeys] speedo questions, Bluehealey |
| Indexes: | [Date] [Thread] [Top] [All Lists] |