So I was having signal light cancellation problems---so I removed the three set
screws and backed out the assembly far enough to access the round metal disc. I
rotated it until I got the cancellation that I liked.
My concern-------------------the assembly now does not fit flush to the
steering wheel hub. There is a noticable gap between it and the hub.
I noticed that on the metal disc there is a 90 degree "foot" coming off of it.
Does this foot go in a special spot on the hub? If so, that might answer why I
have such a noticable gap.
Even so, everything works as it should--horn blows, signal lights work and
cancel--it is just the gap that bugs me.
Any hints? Does your assembly fit flush up to the steering wheel hub?
Thanks
tom
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|