FYI, I was worried about the tapered end and got it to snug up just fine. All
is good. Thanks everyone.
Sent from my iPhone
Chris Scholz OD
> On Mar 11, 2016, at 11:38 AM, Chris Scholz <drscholz@visioncenterpc.com>
> wrote:
>
> Crazy question. What are the threads for the female nut on my temperature
> probe? My thread gauge says 18 per inch and Nissinger Instruments mailed me
> a coupler to fit this temperature probe into the aluminum block of my chevy
> LS1 V8. The coupler in the photo below is 3/8" British Standard pipe on the
> left side which supposedly fits into my brass nut. This coupler screws in 2
> turns and then I meet lots of resistance. I am nervous to crank on it, in
> fear that I will ruin my brass nut on the probe. I am putting this coupled
> probe in a machined frost/casting plug on my block. Any advice? Thanks.
>
> <IMG_1434.JPG>
>
>
>
> <IMG_1435.JPG>
>
>
>
> Sent from my iPhone
> Chris Scholz OD
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/drscholz@visioncenterpc.com
>
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|