I'm guessing 3/16" would be about right. Measure the combined thickness of the
shroud and pan metal and allow about 1/16" to be peened over by the rivet gun
(or squeezer).
You could trim the quarter-inch rivets:
http://www.aircraftspruce.com/menus/to/rivet_3cutters.html
Bob
--------------------------------
Bob Spidell - San Jose, CA
----- Original Message -----
From: "Michael Salter" <michaelsalter@gmail.com>
To: healeys@autox.team.net
Sent: Friday, September 14, 2012 7:07:18 AM
Subject: [Healeys] Rear Shroud Rivets
I've been trying to find the original flat head aluminum rivets used to
attach the rear shroud.
I've purchased some that are 1/4" long but I think that is too long for
this application.
Does anyone have any idea what the original length of these rivets was?
Thanks,
--
Michael Salter
*I have BJ8 water pump kits!!*
_______________________________________________
_______________________________________________
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|