25/32" ID, 1-3/32 OD, .06 thick. Take your plug down to the hardware store.
John
At 06:03 PM 4/27/2012 +0000, Bob Spidell wrote:
>I think it's 3/4" ID (hopefully, someone can un/confirm).
>
>Or, you can just anneal the one you have: heat it to 'cherry red'
>with a propane torch and let cool. Will seal as good as new.
>
>
>Bob
>
>
>--------------------------------
>Bob Spidell - San Jose, CA
>
>----- Original Message -----
>
>
>Can someone give me the dimensions for the copper washer used to seal the oil
>drain plug on BN7? I need a new one and don't have time to order from Moss.
>I assume I can get one of the proper size locally.
>
>Thanks,
>
>Ron Fine
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>Suggested annual donation $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>
>Healeys at autox.team.net
>http://autox.team.net/mailman/listinfo/healeys
>
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/jmsdarch at sbcglobal.net
|