It's simple. Oil goes in a hole in the valve cover and comes out from the
front and rear mains, the pan gasket, the
valve cover, the carburettors, etc.
Bob
On 8/16/2011 3:29 PM, S and T Miller wrote:
> I have never seen a diagram of the 6 cyl Healey engine oil passages. Is it
> oil pump, pressure relief valve, oil filter, rod/ main bearings, cam bearings,
> rockers, drain to tappets? Are there any branch out points or is it a direct
> run? Where is the pressure gauge line in the run? Just curious.
>
> The Millers
> "British Car Nuts"
>
> 1957 Austin Healey 100-6 BN4 35299
>
> 1959 Austin Healey 100-6 BN4 77219
>
> 1964 MGB 40841
>
> 1960 Austin Healey Bugeye Sprite AN5 34351
>
> "Always drive them, but remember each drive in an antique car is a test
> drive."
> _______________________________________________
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|