| To: | <healeys@autox.team.net> |
|---|---|
| Subject: | [Healeys] remountinbg rear bearing |
| From: | Richard Kahn <tahoehealey@hotmail.com> |
| Date: | Mon, 30 May 2011 18:16:09 -0700 |
I have removed the rear bearing in order to replace the seal. I am putting the same bearing back in. It came out easily but will not go the last 3 mms to sit against the new seal. I have used a vice to force it in but no joy. I am thinking of using a torch to heat the hub but I don't want to harm the new seal. Any other suggestions? Thanks' Richard Kahn _______________________________________________ Healeys@autox.team.net Donate: http://www.team.net/donate.html Suggested annual donation $12.75 Archive: http://www.team.net/archive Forums: http://www.team.net/forums |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Healeys] Formerly Chatter, Then Conclave vs Jamboree, Now Boy Scouts - With some Healey content., HealeyRick |
|---|---|
| Next by Date: | [Healeys] remountinbg rear bearing, Richard Kahn |
| Previous by Thread: | [Healeys] Formerly Chatter, Then Conclave vs Jamboree, Now Boy Scouts - With some Healey content., HealeyRick |
| Next by Thread: | [Healeys] remountinbg rear bearing, Richard Kahn |
| Indexes: | [Date] [Thread] [Top] [All Lists] |