I've got a question about the tolerance where the A arm/ kingpin meet
: the manual says there should be a tolerance of 0.002" once the
threaded bushes have benn turned back one flat.
Fine, only the cork rings don't sit all the way into their recess,
and I think that the compressed cork rings would make a feeler guage
measurement impossible.
So, are my cork rings too thick, and should I trim them before
fitting the a A arms (lower wishbones).?
Thanks
Stephen, BJ8
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|