All the studs I saw had coarse threads on the 'short' end--the one that
goes into the manifold. But, yes, theoretically you could do that.
Kinda wonder why Austin used fine/fine.
bs
Richard Ewald wrote:
> Other than the fact you would have to buy a handful of coarse nuts, is
> there any reason you could not use coarse / fine studs?
> Rick
>
> >>'Standard' studs--the kind you can get at the hardware store--are
> coarse thread on one end and fine on the other. I need fine on both ends.
>
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|