Did this a few years ago. IIRC, I wrapped the wires of the harness and bullet
connectors tightly with thin mechanic's wire--use as little as possible--and
used the wire to pull the harness through. I believe the wires of the harness
are cut to different lengths to facilitate this process.
Bob
Steve wrote:
> Hi all,
> During my restoration, a few years ago I removed my
> trafficator harness and now that my steering wheel is restored I've been
> trying to reinstall the trafficator harness. I should mention that the
> original bullets are still soldered on the ends. I've tried running
> bailing wire up the tube and pulling the harness back through but it
> gets jammed up at the opening. So I tried heavy duty fishing line but
> the second or third bullet just gets jammed and am wondering if anyone
> has successfully reinstalled the trafficator with the bullets still on
> and if so, how did you do it or do I need to cut off the bullets and
> pull it through and then solder new ones on? I wanted to avoid the
> latter if possible but if not, oh well.
>
> As always many thanks,
> Steve Meyer
> 61 BN7
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|