re: "Noting that there isn't a bleed screw anywhere ..."
It's on the slave cylinder.
bs
Phil, I would recommend installing the clutch bleeder extension from Mr.
Finespanner with a Speed Bleeder on the end. Makes the job so much easier.
Bruce Steele
1960 BN7
Brea, CA
>I was attempting to bleed the clutch on my '58 BN4, and accidentally
> twisted off the end of the pipe (last inch) underneath the car. Noting
> that
> there isn't a bleed screw anywhere, has anyone else cut the pipe back a
> little
> ways and installed a short piece of pipe with a bleed screw on it? Also,
> is
> it possible to put in a section of rubber fuel line to bridge the gap?
>
> Thanks
> Phil
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|