Back ground;
Had my traficator gone through and rewired. Cleaned up the bakelite and
plastic horn center myself. Unfortunately I did not re -chrome the turn signal
at that time. I decided to take it apart and get the turn signal re chromed.
Removed the plastic and paper protecting it and the bakelite part of the
traficator was broken in peaces. I glued it together with supper glue(gel).
I had model glue but that does not dry fast enough. I Used the model glue
on one of the tabs that broke off on the horn part.
My question is I would like it reinforced so it wonbt fall apart after prime
it and getting it painted. Any ideas?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|