After carefully disassembling , and labeling the "rear seat back" wood
pieces on my BT7 I noticed something. The long top wood piece has a
non-original twist which is going to make for an interesting reassembling
process. One end is in a flat plane and the other end appears to angle
upward which would give the attached flat wood piece a bit of an upward angle.
Does the flat wood piece that is attached to the top of the "rear seat back"
have a slight upward angle to it or is it suppose to be a 90 deg. angle to the
seat back.
I know these pieces are available to buy but I'd rather save the $200.00
and reuse the old parts.
Sorry, this is a bit wordy . Its the best I can do considering I have
a common case of "cabin fever". Old Man winter just won't give up his hold,
but the basement works very well for interior work.
Thanks, Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|