Knibbling bearing.
Best--Michael
--------------------------------------------------
In a message dated 3/10/2008 8:44:15 P.M. Eastern Daylight Time,
richchrysler@quickclic.net writes:
Hello all,
I am going through the complete rebuilding of a '56 BN2 four cylinder engine.
Everything was removed from the block for cleaning, etc. While at the machine
shop undergoing cleaning, a 1/" diameter precision steel ball came out of the
block from somewhere!
**************It's Tax Time! Get tips, forms, and advice on AOL Money &
Finance. (http://money.aol.com/tax?NCID=aolprf00030000000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|