Greg,
It's the ball bearing / plunger / spring at the OD hydraulic pump. See the
picture at the start of Part 2 -
http://www.team.net/www/healey/tech/big_hly/od/delborder_od.html
Have you hooked up a pressure gauge to the OD yet?
Bob
Greg Lemon wrote:
>
> Anyway I read a good article about the hydraulic part of the O/D that talks
> about weak non return valve springs being a likely fix for low pressure.
> However neither the article http://www.ntahc.org/techtips/OVERDRIVE1.html
> nor my factory workshop manual identifies this part. Can anybody help point
> this part out and can it be removed, service, withought completely
> dismanteling the O/D? That and any other thoughts on the problem are
> welcome, still hoping it is electrical, but that hope is dwindling as I test
> and diagnose.
>
> Greg Lemon
> 54 BN1
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|