Mark,
They are like the connectors used in the rear license plate lamp (might be the
same). They're made from sheet stock and rolled/formed to look like an
elongated bell. It's a solderless connection. You feed the wire through the
connector till the bare wire sticks through the small end, then fold the bare
wire back on to the connector.
There's also a steel/rubber cover that used to seal the cavity where the
connections are made. It has two holes for the leads and one hole in the
center
for a screw to attach it to the horn. At one point, Roger Moment was selling
the rubber portion.
Bob
Mark and Kathy wrote:
>
> I have the original Lucas disc type horns that came on my BT7 but have know
> idea what the connectors to the horns look like.
|