| To: | toj@jmc.no, healeys@autox.team.net |
|---|---|
| Subject: | Re: Heater control knob removal |
| From: | LarryRPH@aol.com |
| Date: | Sat, 2 Sep 2006 14:02:25 EDT |
Tomas, If you look closely, you will see a hole in the plastic on the shaft. Insert a sharp point from a needle or safety pin into the hole and push it in while pulling the knob. It should come off. Larry Wysocki BN 6 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Heater control knob removal, MBran89793 |
|---|---|
| Next by Date: | Adjusting 2" SU Carburetors, Ned Smith |
| Previous by Thread: | Re: Heater control knob removal, MBran89793 |
| Next by Thread: | RE: drain tubes on carbs, Carole and Jonathan Quandt |
| Indexes: | [Date] [Thread] [Top] [All Lists] |