| To: | Bluechipracing <bluechipracing@snet.net> |
|---|---|
| Subject: | Re: Bleeding brakes, BN2 |
| From: | Alan Schultz <alan@andysnet.net> |
| Date: | Thu, 10 Aug 2006 21:35:51 -0500 |
It has been stated many times that honing an aluminum cylinder will not work. Is your master cylinder aluminum? It should have a sleeve installed then honed. Alan Schultz 67 BJ8 Bluechipracing wrote: >I just rebuilt the master cylinder on my BN2. Honed the bore and installed >rebuild kit....all new rubber etc. Now I'm bleeding the brakes, and I can't >seem |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: A question for the list, Bob Spidell |
|---|---|
| Next by Date: | Re: Bleeding brakes, BN2, Bluechipracing |
| Previous by Thread: | Re: Bleeding brakes, BN2, 63AHBJ7 |
| Next by Thread: | Re: Bleeding brakes, BN2, Bluechipracing |
| Indexes: | [Date] [Thread] [Top] [All Lists] |