I had the exact problem and figured it was due to the front section of the seat
back cover being too narrow. I had hoped it would stretch out and conform
better with repeated use.
--
Tim Davis BN7
> I had no problem installing the seat bottoms but when slipping the seat back
> covers over the frame its a very tight fit side to side. This causes a big
> gap in the lower back area that even when warmed up and stretched it seems
>it
> would be hard to get the lower back to stay glued down after pressing it in
> place. Plan is to place the other seat back on top and weight it down to
> hold in place but wanted to see if anyone else had seen this when fitting
>them.
>
> Much thanks,
> Sean Sexton
> 62 BT7
|