| To: | "Healeys" <healeys@Autox.Team.Net> |
|---|---|
| Subject: | REmoving Master Cylinder |
| From: | "Ben Prince" <blprince2@comcast.net> |
| Date: | Fri, 24 Dec 2004 11:33:33 -0800 |
How does one remove the master cylinder from a BN!? It looks like it will take a circus contortionist to un-screw the tubes on the top. Perhaps one could remove the carbs and work from above, but that would be a hassle. Re-installing the master cylinder looks even worse. Getting one's fingers into a position to start the tubes will be a trick. Yes, I have slot-box-end wrenches. Your help is greatly appreciated. Thanks, Ben |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Lambert 3.54 Gears, Frank Golding |
|---|---|
| Next by Date: | Two or three point seatbelts?, scott willis |
| Previous by Thread: | Lambert 3.54 Gears, Frank Golding |
| Next by Thread: | Fw: REmoving Master Cylinder, Rich C |
| Indexes: | [Date] [Thread] [Top] [All Lists] |