I removed my TR6 type A OD box out of the TR3 race car today. It was removed
because the last time on track, it was leaking badly.
To my surprise, I found that the OD adapter plate was very loosely attached to
the rear of the transmission, in fact two bolts had completed backed out and I
found them when I removed the accumulator piston cover. Upon further
disassembly I found that all of the adapter bolts were loose.
When I built this transmission 2 years ago, I used red locktite on all of these
bolts. I also had use the thin gasket with hylomar. Has anyone every seen these
bolts back out like this before? Any suggestions on repair work to make sure
this doesnâ??t happen again?
Iâ??m thinking of drilling all bolt heads and safety wiring all of the. Have
also thought of using helicoil on all of these since they are threaded into
aluminum.
Appreciate all thoughts on the mater.
Greg
Sent from my iPhone
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/mharc@autox.team.net
|