I got some good suggestions on how to remove this bush, including Randall?s
below and Fred?s, but Mark Craig reminded me that I may not want to use a
helicoil, which might fail at the track, and I?m better off starting over with
another differential housing. As I only have about seven of them, I have no
good excuse other than I was feeling lazy about starting the whole process
over.
Better than a ruined track weekend, and good thing I did not need this spare
for the last two years I?ve been hauling it around. I had mostly rebuilt it
but was never quite satisfied with the lash. However, I torqued it up and
figured it would do in a pinch. I guess the last time I tightened the bolts,
the one bolt must have been hanging on by a thread (is that where the saying
came from?) and re-adjusting the lash five times must have done it in.
Thanks as always to the group for the good advice and for getting me back on
track.
On Sep 5, 2017, at 9:42 PM, Randall <TR3driver at ca.rr.com> wrote:
It's possible I'm confused, but I think you're talking about what the
British call a "Bush, bearing cap".
TRF seems to have them available, P/N 60070, $1.35 each.
Here's the parts diagram I looked at (since I'm away from home where I have
a paper copy)
https://www.canleyclassics.com/triumph-gt6-mkiii-rear-axle-centre-details
You might also try to find a tap that will just barely bite into the inside
diameter. Looks like maybe 10mm would do. You'll also need something for a
spacer that will fit over the bush, probably a cutoff bit of 1/2" cast iron
water pipe would do. Turn the tap into the bush just a short distance, then
drop the spacer and a heavy flat washer over the tap, and turn a nut down
the tap. Should walk the bushing right out. I've not tried this on a GT6
diff, but it works well in similar situations.
Of course the threads will weaken the bush a bit, you'll have to judge how
critical that is. IMO the bush is mostly to make sure the cap is precisely
aligned, and the bush takes little or no side force once the bolts are
tightened. But I could be mistaken.
-- Randall
> -----Original Message-----
> From: Fot [mailto:fot-bounces at autox.team.net] On Behalf Of
> Scott Janzen via Fot
> Sent: Tuesday, September 5, 2017 9:06 AM
> To: 'Friends of Triumph' Triumph
> Subject: [Fot] GT6 differential and general question
>
> After carefully setting up the gear lash on a spare diff, I
> torqued the bearing cap bolts on the differential carrier for
> the last time, and one of them stripped.
> I can put a helicoil in, but in the process I will loose the
> steel locating sleeve on this bolt hole that helps hold the cap.
>
> I can't remove the sleeve without destroying it. Several questions:
>
> What's the proper name for these "sleeves", if I want to try
> to get one from McMaster Carr, or where can I get them?
>
> Is it essential? I assume these are there because they take
> some side thrust from the carrier.
>
> I can start over with another diff casing - maybe the best
> thing to do. Just hate to have to strip and clean another
> one up, replace seals, adjust the gear lash again!
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20170905/e8031021/attachment.html>
|