http://www.bokers.com/washers.asp?gclid=CjwKEAiAkuLDBRCRguCgvITww0YSJAAHrpf-bGE1LEP4rw6GNnk--UMElG2XTfvvzeDD4TOZDFPI6RoC0Jfw_wcB
Just so you all know...
On 1/13/2017 9:03 AM, Oudesluys wrote:
> Not for a few washers popped in a sturdy envelope as regular
> unregistered mail!
> Kees Oudesluijs
>
>
> Op 13-1-2017 om 16:27 schreef Neil Anderson:
>> Bob,
>>
>> FWIW, there would be no VAT on export orders from the UK, but
>> shipping is getting really expensive.
>>
>> Neil Anderson
>> BT7
>>
>> On Thu, Jan 12, 2017 at 11:04 AM, Bob Spidell <bspidell at comcast.net
>>
>> Well, I went ahead and ordered from Moss. I did a cursory check
>> of the interwebs didn't turn up anything of those dimensions here:
>>
>> https://www.mcmaster.com/#standard-washers/=15uvd84
>> <https://www.mcmaster.com/#standard-washers/=15uvd84>
>>
>> and here:
>>
>>
>> http://www.keybellevilles.com/bellevilles/sampleCatalog.php?gclid=CMCHjPHOuNECFQGRfgodVAoFuA
>>
>> <http://www.keybellevilles.com/bellevilles/sampleCatalog.php?gclid=CMCHjPHOuNECFQGRfgodVAoFuA>
>>
>> and others, and I need to get this car back together before I
>> start losing the little bits. FWIW, SC Parts and AH Spares have
>> them at a more reasonable price--esp. with the current exchange
>> rate--but with VAT and shipping it's not a massive savings.
>>
>> My thanks to Olin, Bob and others who responded; if I come across
>> these in this size I'll make a note for future reference. Now,
>> at least, I know what they're for and how to stack them.
>>
>> Bob
>>
>>
>> On 1/10/2017 2:14 PM, Olin Brimberry wrote:
>>> Bob,
>>>
>>> I figured height of the spring was also important, so I put 2 together
>>> and measured the height with calipers
>>> Height of 2 washers: 0.100 inches
>>> Height of 1 washer: 0.050 inches
>>> Thickness of washer: 0.025 inches
>>> Checking the previous diameter dimensions with a caliper, I get:
>>>
>>> ID: 1.057 inches
>>> OD: 1.5 inches
>>>
>>> I suspect that the ID is originally spec'd to be 1-1/16" but because of
>>> the slight "spring", the diameter is slightly less. Good luck
>>>
>>> Olin K. Brimberry, PE
>>> Principal Engineer
>>> Office -919.803.4274 <tel:%28919%29%20803-4274>
>>> Mobile -919.522.1608 <tel:%28919%29%20522-1608>
>>>
>>> HunterBane Engineering, PLLC
>>> PO Box 10314
>>> Raleigh, NC 27605
>>> 3306 Alamance Drive
>>> Raleigh, NC 27609
>>>
>>>
>>>
>>> -----Original Message-----
>>> Sent: Tuesday, January 10, 2017 4:34 PM
>>> Subject: RE: [Healeys] Belleville washers in BN2 steering box
>>>
>>> I just pulled mine out of a steering box I am rebuilding, and yes there
>>> are 6 positioned as such: ()()() Where only the outer edges touch. The
>>> dimensions are as follows:
>>>
>>> ID: 1-1/16
>>> OD: 1-1/2
>>> Pictures of the measurements are attached for verification purposes.
>>>
>>> The washers were loose on the shaft, but I think the closer tolerance
>>> is going to be on the OD side.
>>>
>>> Olin K. Brimberry, PE
>>> Principal Engineer
>>> Office -919.803.4274 <tel:%28919%29%20803-4274>
>>> Mobile -919.522.1608 <tel:%28919%29%20522-1608>
>>>
>>> HunterBane Engineering, PLLC
>>> PO Box 10314
>>> Raleigh, NC 27605
>>> 3306 Alamance Drive
>>> Raleigh, NC 27609
>>>
>>>
>>>
>> _______________________________________________ Support Team.Net
>> http://www.team.net/donate.html <http://www.team.net/donate.html>
>> Suggested annual donation $12.75 Archive:
>> http://www.team.net/archive Forums: http://www.team.net/forums
>> http://autox.team.net/mailman/listinfo/healeys
>> <http://autox.team.net/mailman/listinfo/healeys>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/healeys/neilandcustom at gmail.com
>> <http://autox.team.net/mailman/options/healeys/neilandcustom at
>> gmail.com>
>>
>>
>> _______________________________________________
>> Support Team.Nethttp://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive:http://www.team.net/archive
>> Forums:http://www.team.net/forums
>>
>> Healeys at autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> Unsubscribe/Manage:http://autox.team.net/mailman/options/healeys/coudesluijs
>> at chello.nl
>>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/frogeye at
> porterscustom.com
>
-- Dave Porter Porter Custom Bicycles 2909 Arno St. NE Albuquerque, NM
87107 505-352-1378 Go HERE: my world www.porterbikes.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170113/668e9f81/attachment.html>
|