Moroso 46160
-----Original Message-----
From: "J.C. Hassall" <jhassall@blacksburg.net>
Sent: b3/b20/b2013 6:38 PM
To: "fot" <fot@autox.team.net>
Subject: [Fot] TR4-6 wheel stud knurl OD?
Anyone happen to know the OD of the press-in wheel studs for TR4-6?
Most of the p/n I've found are just a tad over the 0.494 ID I've
measured in the hub, so the knurl OD could be a sticky issue. I need
longer studs in 7/16x20 thread, so need to order larger and drill the
hubs. Anyone have a favorite p/n?
tnx
jim
--
Jim Hassall
Blacksburg VA
'63 TR4 in autox preparation
99% finished, 90% to go
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/fot/yellow-green@sbcglobal.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|