Kas and I have been discussing some issues that I'm experiencing with the
GT6 intake and header.
After looking at a friends Spit with a PRI header which has this huge plate
to bolt to the head,
I am wondering if I should try and design a "sandwich" plate to mate up to
the intake and header?
http://www.gt6.ca/08/1018/slides/DSCN4027.html
If it was done right and thick enough, I figure it would provide a means to
ensure even pressure across the various pieces.
As Kas just told me, the head was designed by a tractor guy!
Suggestions/thoughts.
Its a cold rainy day in Ottawa. So as my driving season is all but done, I
need something to day dream about.
A.
--
Andre Rousseau - andre@gt6.ca
'68 Triumph GT6 MK1 - http://www.gt6.ca/
Ottawa, ON, Canada
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|