I had the best results setting the end play(s) inside the factory TR2/4/6
workshop manual specks; keep in mind that this is at room temp. Loose was not
good. Pay attention to optimizing everything, if you have time.
TR Regards
Hardy
In a message dated 10/20/2008 6:58:43 PM Pacific Daylight Time,
fot-request@autox.team.net writes:
From: Gt6steve@aol.com
Subject: [Fot] TR6 gearbox
To: FOT@autox.team.net
Message-ID: <ca4.3b2b911f.362e58c1@aol.com>
Content-Type: text/plain; charset="us-ascii"
Amici,
Can anyone point me to a good reference for rebuilding the TR6 gearbox? I
broke a spacer in mine this weekend and it has me wondering.
Do I set it up tight with little endplay in the gears or loose so they slam
around ? Where are the critical dimensions and clearances?
I'm using the Moss close ratio gears if that makes any difference...
Steve
**************New MapQuest Local shows what's happening at your destination.
Dining, Movies, Events, News & more. Try it out
(http://local.mapquest.com/?ncid=emlcntnew00000002)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|