== fot at autox.team.net supported in part by Fat Chance Garage
== http://fatchancegarage.com
At 09:40 PM 11/14/2005 -0500, Bill Bartlett wrote:
>Any insight from the group?
Here's an e-mail I saved from another group that addresses
some of that:
=====================================
X-Sent: 6 Jan 2000 04:01:38 GMT
From: "Robert Paul" <rpaul@surfree.com>
To: <shop-talk@autox.team.net>
Subject: Re: Setting up air lines in the shop
Date: Wed, 5 Jan 2000 23:04:04 -0500
X-Mailer: Microsoft Outlook Express 4.72.3110.5
Sender: shop-talk-owner@autox.team.net
Reply-To: "Robert Paul" <rpaul@surfree.com>
X-Info: To unsubscribe send mail to majordomo@autox.team.net with nothing but
X-Info: unsubscribe shop-talk
X-Info: as the body of the message.
Mike,
Thanks for sorting out this address. The diagram makes some very good
suggestions: run headers up high and have drain valves at the bottom of each
drop. Also the idea of cooling the air is a good one.
I looked into piping options a few months ago and came across some stainless
or aluminum tubing and compression fittings to match. In the small sizes,
like 3/4" to 1" range, aluminum has plenty of pressure rating for compressed
air. Stainless is plenty strong, but costs more. Either are better than
black iron (rust) or galvanized (flakes of zinc). Also I've had better
luck sealing joints with compression fittings (not the crap quality fittings
used on toilets) than with screwed pipe. I found the tubing and fittings
in the McMaster-Carr catalog.
http://www.mcmaster.com
Bob
-----Original Message-----
From: Mike Rambour <mikey@b2systems.com>
To: Stephen <slb1@humboldt1.com>; Pauley, Ken <Ken.Pauley@Allin.com>;
shop-talk@autox.team.net <shop-talk@autox.team.net>
Date: Tuesday, January 04, 2000 11:45 PM
Subject: Re: Setting up air lines in the shop
>
>
>>I set my compressor plumbing the way TIP Tools suggests. I used 3/4"
>>galvanized pipe with risers and drains as they describe. I have attached
a
>>link to their web page that describes the plumbing set up through a link
>>about half way down the page at number 5. The link was not working when I
>>tried so you may want to give it a try yourself.
>
> The reason the link on item 5 is not working is because its missing the
>"www" in the address. I went to the following link as suggested
>http://www.tiptools.com/tech_line/compressors/air_consumption.html
>and on item 5 there is a link which SHOULD look like this to work
>http://www.tiptools.com/compressors/piping_diagram.pdf
>but in the document its missing the "www""
>
> mike
>
>~~~~~ I'd rather be sailing ~~~~~~~and \/ \/ ~~~~~~~~~~~~~~
>Mike Rambour .oooO Oooo.
>Bug Writer er...Programmer ( ) ( )
> \ ( ) /
> \_) (_/
> webmaster@b2systems.com
>***********************************************************************
>If you want to learn more about the ULTIMATE BRITISH sports car, then
>take a look at http://www.singercars.com/
>~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
==========================================
Hope that helps,
R. John Lye
rjl6n@cstone.net
=== unsubscribe/change address requests to majordomo@autox.team.net
|