In a message dated 12/03/2004 12:36:46 PM Central Standard Time,
jaboruch@netzero.net writes:
> I am using Mark Williams axles in my TR 3 rather than the Moser that came
> with the Southwick conversion (I twisted a Moser axle a while back). Anyway,
> these came with threaded holes for the studs, rather than splined. The
> "stud" is basically a high quality bolt. I red locktited them in and they
>have
> not been an issue. If the holes have not wallowed out too big, perhaps you
>can
> thread the hubs.
Mark Williams made the 'custom' axles for our TORNADO TALISMAN, which has a
Herald or Spitfire based rear end. They look great, but we still have not
tested them. Should happen early next spring.
Bill Dentinger
|