Re: TR 4 Cyl Engine Factory Rear Seal and Tool Survey

[Randall <randallyoung@earthlink.net>]

Brad Eells wrote:
> Seems to be a lot of comment out there about the Factory original aluminum
> rear crankshaft oil seal and the dimensions of the tool used to center and
> place the seal. This tool is referred to on Page 1.117 of the TR4 Factory
> Workshop Manual.

FWIW, this is the same tool and dimension that appears in Fig 33, page
B-22 of the TR2/3 Factory Workshop manual.

Randall