In a message dated 7/17/2001 12:22:55 PM Eastern Daylight Time,
Gt6steve@aol.com writes:
> Is there a chronic weakness I don't know about or is this just
> typical? Do these have porous castings? The mating surfaces seem leak
> free.
> I'm suspecting the shifter rods. Anybody have any comments?
>
Make sure the transmission case is vented properly. If not vented, as the
unit heats up pressure occurs and since the gear lube is sprayed everywhere
inside, the pressure venting thru cracks, shift rods, etc., will carry oil
with it. Vent from the top thru a 3/8" or larger tubing to a catch tank.
Make sure there are no low spots for oil to accumulate and effectively block
the venting.
Clark
"If it's not fun why do it?" Jerry Greenfield
Clark W. Nicholls
CWNicholls@aol.com
http://members.aol.com/CWNicholls
fax: 419-844-7564 (yes, 419)
phone: 413-243-3433
|