(no subject)

[SpiwakD@aol.com]

Amici

        A local TR3 racer is planning to reinforce his front hubs by welding 
some metal into the depression between the flanges (perhaps two crescents of 
rebar). I suggested he wait until I sought the advice of the FOT seers. I did 
mention to him the tip about through-bolting the flanges together, but he 
thought the extra holes on the rotor side would weaken the flange. I welcome 
any comments on this project. How many front hub breaks have there been? 
Where do they break?

                                                           Dave