Hi Ted,
On Sep 16, 8:16pm, Ted Schumacher wrote:
> anyhow, the
> simple answer to the problem is to go to a rear axle s\design that has a
> splined hub attachment. granted, a "full floater" diff would be nice,
> but these are not grand national stock cars. if you have interst in
> this, please let me know. the tentative price would be approx. $250 per
> side, based on doing a minimum run of 10 pcs. questions gladly
> answered. production time is now at 12 weeks.
This makes sense to me, the splines should certainly be stronger.
However, this would require special hubs too (with the internal
splines). I assume that the $250 price is only for the axles.
How much additional would the hubs be? Would the hubs have the
same "offset" and bolt pattern and take the same bearings and
seals?
thanks,
John Lye
rjl6n@virginia.EDU
http://avery.med.virginia.edu/~rjl6n/homepage.htm
|