datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] Temp Sensor

To: "Steve Harvey" <stebharvey@ameritech.net>,
Subject: Re: [Roadsters] Temp Sensor
From: "Daryl Smith" <drlsmith@dccnet.com>
Date: Tue, 30 Sep 2008 09:24:43 -0700
Steve,
If this is indeed a 1600 R series engine/head, there are 2 theaded holes in 
front of the #1 cylinder exhaust manifold. If there is not it has been 
welded up, or it is not a 1600 head. I believe the 1500 head is the same, 
don't know about an H20 head. If there is not one there, you may not have a 
1600 R series engine even......
I would suggest you have a VERY close look at it. You may be able to tell if 
it has been welded up or has a plug in it.........
A picture of the area, with a link, because attachments are deleted at the 
server,  would be helpful.

Are you sure the stock temp sensor does't wotk?

Daryl


From: "Steve Harvey" <stebharvey@ameritech.net>

> Group,
>
>
>
> Thanks for the replies. There's only one threaded fitting on the front of
> the intake manifold so I plan on installing a "T" which will allow me to
> install the temp. sensor and leave the current piping that runs to the
> manifold. This should solve the problem. Now to figure out where to 
> install
> the temp gauge in the dash area so it looks good but won't cause a trip to
> the clinic for stitches.
>
> Steve 
________________________________________
Support Team.Net  http://www.team.net/donate.html


Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters

<Prev in Thread] Current Thread [Next in Thread>