Re: Got the Head off!!!! Check out the Pics.

["Andy Cost" <andycost@earthlink.net>]

Yes.  I'm kidding.

If you are going to sand on the piston you should remove it from the motor.
You don't want all that aluminum powder going into the motor.  I've had a
Kawasaki and a roadster motor run for a long time with beat up pistons.
Both had dents where the PO installed spark plugs that were a little too
long.  I didn't seem to notice any detonation because of the gouges.  A
concern might be that a crack could form around the rough edges.

Andy