RE: Clutch Mystery

[Stan Chernoff <az589@lafn.org>]

If the engine plate were missing then it would be very difficult to get the
starter aligned to get correct tooth engagement with the flywheel.

Stan
===========

At 01:21 PM 7/23/03 -0700, Tom Hendricksen wrote:
>What would happen if the steel plate between the bell housing and the engine
>block were missing?  Would that cause the input shaft to bind on the
>crankshaft?
>
>Tom

///  datsun-roadsters@autox.team.net mailing list
///  Archives at http://www.team.net/archive