Mike,
I have seen the comment about metric fittings before. Is it possible to
purchase metric fittings that will thread into the body of the MC, or is the
metal tubing diameter also different than the SAE fittings on the brake
calipers and slave cylinders?
Could the metric fittings be drilled out slightly to allow SAE tubing (assuming
that metric is the smaller of the two)?
Tom
69 2000
SRL311-12401
datsunmike wrote:
> The 240 MC has metric fittings.
>
> Mike
>
> ----- Original Message -----
> From: "Allen Blackmon" <orangedawg@hotmail.com>
> To: <datsun-roadsters@autox.team.net>
> Sent: Friday, June 21, 2002 12:32 PM
>
> > To List,
> >
> > I have a 1970 2000. I am considering, in the future, doing the Volvo
> brake
> > conversion. I understand that you need to use the 240Z brake m/c,
> correct?
> > I may not switch over to the Volvo brakes yet, I'll have to wait and see
> > what condition my calipers are in. My question is that since I've got
> > everything out of my car right now, should I install the 240Z brake M/C
> now?
> > Will it work with my brakes(stock)? Will it hurt to use it now? Other
> > than reservoir size, is there a difference? Will I have to do any
> > modifications to get it to work on my car? What year 240Z is it from?
> Any
> > other info I should know?
> >
> > Thanks!
> >
> > Allen
> > 1970 2000 13774
> >
> >
> > _________________________________________________________________
> > Join the worlds largest e-mail service with MSN Hotmail.
> > http://www.hotmail.com
> >
> > /// datsun-roadsters@autox.team.net mailing list
> > /// Send admin requests to majordomo@autox.team.net or go to
> > /// http://www.team.net/cgi-bin/majorcool
> > /// Send list postings to datsun-roadsters@autox.team.net
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|