Good morning all,
I am nearing the point of starting up my two-liter after subjecting it to a
long, long period of suspended animation. I am wanting to turn the engine
manually to put in a new set of points but can't seem to get at the main
pulley bolt using my 12-inch crescent wrench (even after pulling the fan and
shroud). I tried using a 1" socket, but the bolt is larger. Anyone know
what size the bolt is? Is there a trick to getting a grip on it with a
wrench?
Second, I cleaned the topside distributor contacts and only when I went to
reattach the plug wires did I realize that I have no idea which one goes to
the No. 1 cylinder. Looking at the engine from the passenger side, the
distributor cap has contacts at the 8:00, 10:00, 2:00, and 4:00 positions.
Which is No. 1? Does the distributor turn clockwise or counter-clockwise?
Thanks,
Mark Kalmus
Austin TX
1970 2L
|