Re: Disappearing Fluids

[Roland Dudley <cobra@cdc.hp.com>]

> I then placed the new seal in the freezer with a thermoter and waited. 
> When I hit mius 10C I checked. No change. At minus 40c I checked again. I 
> small change! After three hours the seal was three thou smaller!! THis 
> would be enough under pressure to loss the lot I think.

About how much metal can be honed from the bore of a master or wheel
cylinder during the rebuilding process?  I would think it would be hard 
to take off less than 2-3 thousandth.

Roland