| To: | british-cars@hoosier.cs.utah.edu |
|---|---|
| Subject: | TR6 rear hub adjust |
| From: | ian@Centric.COM (Ian Macky) |
| Date: | Thu, 29 Oct 92 16:14:29 PST |
The topic that wouldn't die...
I got the brand new adjuster hardware from Moss today. I wish the stuff on
my hub looked so good... Anyway, I measured them:
Adjuster: 2.045"
Locknut: 2.05"
Bogus! A 2" wrench won't fit those since they're nominally 2.00".
Note however that 2.05" * 25.4mm/in = 52mm exactly. A scan of the ol'
SnapOn catalogue reveals *BZZZZZZZT* nothing! No metric wrenches this
size.
I think I may finally throw in the towel on this one, and I don't give up
easy....
--ian
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: 3M adhesive (Was: TR6 interior misc.), Scott Alexander |
|---|---|
| Next by Date: | Re: TR6 rear hub adjust, Rich Hill |
| Previous by Thread: | FW: wanting engine suggestions for europa S2, DaveVH |
| Next by Thread: | Re: TR6 rear hub adjust, Rich Hill |
| Indexes: | [Date] [Thread] [Top] [All Lists] |