| To: | Glenn Stauffer <stauffer@cc.swarthmore.edu> |
|---|---|
| Subject: | Re: MG Midget Clutch Release Bearing |
| From: | "Chris Kent Kantarjiev" <cak@parc.xerox.com> |
| Date: | Mon, 10 Aug 1992 15:20:39 PDT |
On another subject, I'm derus ting all the suspension bits using a
wire
brush, steel wool, and acid.
Eastwood sells a nice wheel for use with a drill that's basically
looseweave scotchbrite plastered with silicon carbide. Really good at
getting anything off, leaves a finish like 80 grit sandpaper.
Name: Eastwood Company
Address: 580 Lancaster Avenue
Box 296
Malvern, PA 19355
Phone: (800) 345-1178
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Just who the heck is Delaney Gallay, anyway, Roland Dudley |
|---|---|
| Next by Date: | Re: Su carbs and ljc's, Scott Fisher |
| Previous by Thread: | Re: MG Midget Clutch Release Bearing, Scott Fisher |
| Next by Thread: | Re: MG Midget Clutch Release Bearing, Glenn Stauffer |
| Indexes: | [Date] [Thread] [Top] [All Lists] |