Greg, I don't think there is a whole lot of difference in the prices. I
think it is just a matter of personal preference.
George.
George J. Malaska, VIN#768,#1548.
Membership Director, Bricklin International
Elkhart, IN. 219-875-1270
bricklingeorge@msn.com.
----- Original Message -----
From: Greg Monfort <wingracer@email.msn.com>
To: Bricklin <bricklin@autox.team.net>
Sent: Friday, April 02, 1999 6:19 PM
Subject: Fw: GLUE,FIBERGLASS,COMPRESSORS
> My tank displaces approx. .37cuft.. At .24cfm, it should take ~1.6min. to
> fill from empty. Is continuos duty necessary or worth the extra cost, even
> with some leakage?
>
> GM
>
>
> ----- Original Message -----
>
> > As far as which compressor to use, I have always used the Thomas
> > 405ADC38/12. It is rated at 100# max. but I had a regulator set at 115#
> and
> > it never had a problem getting to that pressure. It is a continuous
> pressure
> > compressor(it can run for long periods) where the other suggested units
> > (215ADC38/12 and 315CDC56/12) are intermittent duty compressors. They
can
> > run for 5 minutes and then must be off for 20. Granted, if you have a no
> > leak system the intermittent units should be OK but I have had nothing
but
> > good luck with the 405 unit.
> > George.
> >
> >
> > George J. Malaska, VIN#768,#1548.
>
>
>
|