I totally agree. Thought I'd ask anyway.
Tricky bit is getting something fabricated. I am so tempted to buy my own
planishing hammer!
> On May 19, 2015, at 11:19 AM, "Larry Young via 6pack" <6pack@autox.team.net>
> wrote:
>
> The only way to do it is cut out the bad metal, make patch panels and weld
> them back in. The patch panels don't sound that difficult to me, especially
> since most of it will not show. You may have to do some grinding and use
> some bondo, but bondo over steel is better than bondo over fiberglas.
> Larry Young
>
> On 5/18/2015 10:50 AM, James_ via 6pack wrote:
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> 6pack@autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/6pack/jattr6@hotmail.com
>
_______________________________________________
Archive: http://www.team.net/archive
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
|