I had several questions on shifting into reverse for my transmission and the
answer is that this seemed OK. No grinding or difficulty that I noted. Does
this mean clutch is good since there are no syncros involved?
Darcy Hunter
'73 TR6
No. Easton, MA
_____
From: DLylis@aol.com [mailto:DLylis@aol.com]
Sent: Tuesday, February 10, 2009 6:53 PM
To: Darcy_Hunter@Instron.com; 6pack@autox.team.net
Subject: Re: [6pack] Transmission rebuild
In a message dated 2/10/2009 1:29:14 P.M. Eastern Standard Time,
Darcy_Hunter@Instron.com writes:
I suppose not every bell housing bolt is required to make this check. Thanks
That is not something I would advise, but that is me. I do not think that if
it is the clutch that is the issue, that it is the part that is bolted to the
flywheel. I would think that it is in the fork, TOB area, or hydraulics.
How was shifting into reverse before you took it out?
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
_____
Nothing says I love you like flowers!
<http://yellowpages.aol.com/search?query=florist&ncid=emlcntusyelp00000001>
Find a florist near you now.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|