Hello,
I need to install the 4 rubber wedges that keep the hood/bonnett from rubbing
against the inner fenders when it's down. The problem is that I replaced the
tops of my inner fenders, so the holes are gone. I'd like to position them as
close as possible to the original location.
Could someone please take a moment and measure the location of the center of
their bonnet buffers from a reference point, such as the cowl panel or the
bonnet support cones? I notice there's a raised boss stamped in one place
toward the aft side of the inner fenders; does one set of buffers go on this?
Finally, does the flat bottom side of the buffers go all the way down against
the fenders, or are they "raised" to some degree?
Thanks again, Tom
CC55483L
http://www.triumphowners.com/735
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|