Take said punch, wrap some electrical tape around all but an inch from the end
to buffer the plastic disk (or not..), then using a wide blade stubby
screwdriver lever the disk/crank gently apart to reveal the pin. You can push
the disk towards the door panel with your other hand to assist it. Insert end
of punch into the hole, remove stubby screwdriver and gently knock out the
pin. When the pin is finally ejected the whole lot will go "poing" and fall on
the floor.
Stan
-----Original Message-----
From: 6pack-bounces+stan.foster=hp.com@autox.team.net
[mailto:6pack-bounces+stan.foster=hp.com@autox.team.net] On Behalf Of robert
fabie
Sent: Saturday, January 12, 2008 6:27 PM
To: lfm614@aol.com
Cc: TR-6 list
Subject: Re: [6pack] window crank removal tool
Thanks, Lou, but the tool I need is the one that separates the door panel
from the window crank in order to expose the pin. Any ideas on that tool?
Thanks again.
Bob
On Jan 12, 2008 6:10 PM, <lfm614@aol.com> wrote:
> A small punch or long thin nail will work to push out the pin. It is the
> diameter of a wire coat hanger.
>
> Lou
> ------Original Message------
> From: robert fabie
> Sender: 6pack-bounces+lfm614=aol.com@autox.team.net
> To: TR-6 list
> Sent: Jan 12, 2008 3:35 PM
> Subject: [6pack] window crank removal tool
>
> Can someone recommend the best tool for removal of the window crank and
> inside door handle? Will a "conventional" window crank removal tool work,
> i.e., one that is designed for a GM product, work?
>
> Thanks
> Bob Fabie
> '75 TR6
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|